twin power harness RE-install/anyone see the problem?
09-04-05, 11:44 AM
#1
Senior Member
Thread Starter
Join Date: Mar 2001
Location: Waldorf, MD
Posts: 288
Likes: 0
Received 0 Likes
on
0 Posts
twin power harness RE-install/anyone see the problem?
I know there are several threads on this, I've looked through them and still can't figure it out. My twin power was disconnected and I'm trying to reconnect it. It's grounded and connected near the battery but the two other terminals are not connected to the leading and trailing coils apparently. If anyone can see what needs to be done I'd appreciate it. Trying to take my car to the track tomorrow and I'd like to have this up and running again. The car starts fine and the red light on the unit does not turn on when I start the car. Thanks.
09-04-05, 12:06 PM
#3
Senior Member
Thread Starter
Join Date: Mar 2001
Location: Waldorf, MD
Posts: 288
Likes: 0
Received 0 Likes
on
0 Posts
No, I know it works fine. Ray at PFS unplugged it cause my dyno #'s didn't look right, ended up being plugs and wires. So I just think he left it unhooked. Then the leading coil was replaced. It's wired to the battery fine, I just need to know if the last pic is the 4 pin that it needs to be attached too. I can go take some better pics if need be.
09-04-05, 04:16 PM
#6
Senior Member
Thread Starter
Join Date: Mar 2001
Location: Waldorf, MD
Posts: 288
Likes: 0
Received 0 Likes
on
0 Posts
Well, it said in the instructions to mount in a cool place. So I thought the coolest part would be near the battery. The wires reach is fine. Plus I didn't feel like making a bracket...I'm LAZY!!!
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM