ticking noise when I release the throttle
#26
Lives on the Forum
Originally Posted by ech
The TSB adds a rubber isolator to the mounting point that holds the brake booster line. You can't keep the valve from fluttering/ticking, but the isolator does a good job of removing the noise from the cabin. For $5-$15 and a few minuts, it is a good thing to do.
TSB 011/97.
F285-13-363 - Rubber Mounting - about $11 (a "stud") - this is the only part you have to order from Mazda
9994-00-600 - Flange Nut - about $2 - yes, for a single brass 10mm nut! A good place to save $2, if you don't mind a trip to the hardware store, or rummaging through that big bin of spare hardware you have.
TSB 011/97.
F285-13-363 - Rubber Mounting - about $11 (a "stud") - this is the only part you have to order from Mazda
9994-00-600 - Flange Nut - about $2 - yes, for a single brass 10mm nut! A good place to save $2, if you don't mind a trip to the hardware store, or rummaging through that big bin of spare hardware you have.
You can get the stud from Mazda Motorsports for less than $5.
#28
Well the TICKING and GRINDING noise when at idle, and when I take foot off gas, is now HISTORY! That TSB worked, all it took was a flange nut and rubber mounting where the brake hose attaches to the firewall on the drivers side. It was VERY loud inside my cabin, I cannot believe that a little rubber mount completely got rid of it. It was unbelievable annoying.
So for those that still have this noise, do the TSB on your FD, you wont be dissapointed.
RXJoey
So for those that still have this noise, do the TSB on your FD, you wont be dissapointed.
RXJoey
Thread
Thread Starter
Forum
Replies
Last Post
Linda_Lovelace
General Rotary Tech Support
0
09-18-15 10:04 PM