Sun visor fix?
#1
Senior Member
Thread Starter
Sun visor fix?
The little plastic dowels that hold the sun visors in have completely fallen apart.
Has anyone already worked out a solution for this, besides replacing the sun visor?
I was thinking ordering some plastic tube and putting it over the visor.
I measured it at about .370 OD and .230 ID for the original part.
Has anyone already worked out a solution for this, besides replacing the sun visor?
I was thinking ordering some plastic tube and putting it over the visor.
I measured it at about .370 OD and .230 ID for the original part.
#2
I'm pretty **** about my interior, but i was just going to wrap the posts in a few layers of black electrical tape, figuring even I'd never notice it.
Your way is probably better.
I'm also curious to hear if this is a solved problem.
Your way is probably better.
I'm also curious to hear if this is a solved problem.
#3
Just Boosting
iTrader: (8)
I actually have tan visors that the owner before me painted black. So I purchased a great condition black visor here on the forum with that very peace broken. So my fix was to make a cut down the middle the long way on the tan painted black peace and when I did it split in half. I then grabbed both half peaces and glued them very carefully to the black visor and its been good ever since.
Thread
Thread Starter
Forum
Replies
Last Post
den7
3rd Generation Specific (1993-2002)
18
08-07-19 11:15 PM
Tyblat
2nd Generation Specific (1986-1992)
30
01-14-16 08:17 PM