Safe boost level for 2piece seals
#28
imitek
![](https://www.rx7club.com/images/misc/15_year_icon.png)
Thread Starter
got a bosch 3 bar map sensor in with walbro 450 fuel pump my injector duty has droped only by a bit but i have increase my psi now with the new map sensor
this is my log and mapp the most recent
log
https://www.dropbox.com/s/rj9shfn6oa...18psi.mod?dl=0
map
https://www.dropbox.com/s/rj9shfn6oa...18psi.mod?dl=0
what do you guys think its not smooth im slowly trying to hit my 20psi mark my boost gauge reading 18psi but my map sensor reading 16psi
this is my log and mapp the most recent
log
https://www.dropbox.com/s/rj9shfn6oa...18psi.mod?dl=0
map
https://www.dropbox.com/s/rj9shfn6oa...18psi.mod?dl=0
what do you guys think its not smooth im slowly trying to hit my 20psi mark my boost gauge reading 18psi but my map sensor reading 16psi
#29
Full Member
![](https://www.rx7club.com/images/misc/05_year_icon.png)
iTrader: (3)
Join Date: May 2009
Location: Montreal
Posts: 192
Likes: 0
Received 0 Likes
on
0 Posts
Would it be an absurd statement to say you can run OEM 2 piece seals at 25 even 30 psi if you are using AI of water or methanol or a mix of both?
It would seem to be the best compromise on cost of seals and not worrying about wearing out the housings.
Andrew
It would seem to be the best compromise on cost of seals and not worrying about wearing out the housings.
Andrew
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
stickmantijuana
Engine Management Forum
11
11-09-15 01:15 PM
rx8volks
Canadian Forum
0
09-01-15 11:02 PM
rx8volks
Canadian Forum
0
09-01-15 10:46 PM