Rotor housing resurfacing results
#27
I don't think there is really a downside to getting them resurfaced in my opinion. I was nervous about getting them resurfaced at first but when I got them back I was very pleased. Also the housings are supposed to have really good compression because they are very square once they are resurfaced. Also the other person who had a question on the housing being sand blasted they do not appear or fell like they have been sand blasted.
Thanks
Thanks
#28
Full Member
iTrader: (1)
They look great. What are you doing for seals? I'm assuming something softer than the stock apex seals. I know a lot of people have varying opinions on this topic but would a seal like Goopy Performance's apex seals be a good pairing with refinished housings? I know they offer a refinishing option for rotor housings too. J/w
#30
Full Member
iTrader: (12)
Join Date: Apr 2009
Location: new york
Posts: 130
Likes: 0
Received 0 Likes
on
0 Posts
Always good stuff from them. Were you the one I messaged to check them out months ago? I have 20b parts sitting over there. I just need to dig a little deeper into my pockets to finish! I have also had a bunch of housings resurfaced cut by them and ran them with no problems in the half bridge port motor I had. Send them some of your engine rotors if you want to really see some cool machining ****!
Thread
Thread Starter
Forum
Replies
Last Post
cdn
2nd Generation Specific (1986-1992)
14
09-10-15 06:23 AM
cdn
2nd Generation Non-Technical and pictures
0
08-11-15 08:59 PM