robinetas simplified solenoids
#1
rx7philrx7
![](https://www.rx7club.com/images/misc/05_year_icon.png)
Thread Starter
Join Date: Jun 2005
Location: derby england
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
![Question](https://www.rx7club.com/images/icons/icon5.gif)
i have just simplified my solenoid system, but now i am getting four codes. because i have removed some of the valves my ecu is still looking for them i think. i get #25 which is the pressure regulator valve (A), #31 relief 1 valve (B), #32 switching valve (C), #50 double throttle controle valve (G). what should i do to get rid of them, i need to get out of lame limp mode please help.
![Confused](https://www.rx7club.com/images/smilies/confused.gif)
#2
RX-7 Bad Ass
![](https://www.rx7club.com/images/misc/15_year_icon.png)
iTrader: (55)
You need to wire a resistor in for each one of those removed solenoids so the ECU still thinks it's there.
Do a search for "solenoid" and "resistor", and I'm sure you can find more info.
Dale
Do a search for "solenoid" and "resistor", and I'm sure you can find more info.
Dale
#3
rx7philrx7
![](https://www.rx7club.com/images/misc/05_year_icon.png)
Thread Starter
Join Date: Jun 2005
Location: derby england
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
thanks dale
thanks dale, the viton check valves are sweet by the way. hey dale you know on the lower inlet manifold where the turbo control valve was there are two pipes that went to valves A, B can i block them off oh and can i block the pressure regulator pipe off aswell, cheers phil.
Last edited by c.stenson1; 11-12-05 at 03:36 PM.
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
17
06-03-24 03:25 PM
Snook
3rd Generation Specific (1993-2002)
17
02-27-21 02:54 PM
alexdimen
3rd Generation Specific (1993-2002)
20
10-23-15 01:50 PM