Malloy Mazda contact info?
#26
BOOM! remembered it. guess I'm not getting Alzheimer's
hmkparts@aol.com
hmkparts@aol.com
#28
That's good to hear that Mazda has worked through their reman quality issues because I'll probably ordering one from Ray in the next few months. My original motor with 70k on it exhibited the dreaded coolant o-ring failure by barfing all the coolant out the overflow tank in the white castle drive-thru a month ago. I did the block-weld trick which fixed it for now but it's only a matter of time before that gives out too.
#29
pugg57 - just replacing my coolant hoses and filler cap. I finally got a good cover for the car too
mgoddard - how often you drive the car, if not very much it should last you quite a few more miles.
mgoddard - how often you drive the car, if not very much it should last you quite a few more miles.
#30
I average about 6,000 miles a year on it so maybe with some luck the blockweld will hold for a while. However, when my motor decides it's too good to have coolant running through it again I'm prepared to replace it.
#35
Originally Posted by dubulup
is it sad I know the # off the top of my melon?
#38
Thread Starter
Joined: Mar 2001
Posts: 30,580
Likes: 567
From: FL-->NJ/NYC again!
Originally Posted by BATMAN
Rich, why don;t u contact Mazdaformance in TX.
I found that they are cheaper than Malloy.
I found that they are cheaper than Malloy.
#41
Thread Starter
Joined: Mar 2001
Posts: 30,580
Likes: 567
From: FL-->NJ/NYC again!
Originally Posted by badass7
Hey Rich, you should contact a shop in TX called Gotham Racing.
For the love of $$$ who dug this thread up from over 2 yrs. ago ?
For the love of $$$ who dug this thread up from over 2 yrs. ago ?
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
3
08-20-15 10:24 PM
rx8volks
Canadian Forum
0
08-13-15 04:55 AM
rx8volks
Canadian Forum
0
08-11-15 10:30 PM