3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

Intake Manifold Gasket leaking exhaust

Thread Tools
 
Search this Thread
 
Old 06-03-06 | 02:02 PM
  #1  
ddkkww888's Avatar
Thread Starter
Full Member

 
Joined: Feb 2005
Posts: 113
Likes: 0
From: San Mateo, CA
Intake Manifold Gasket leaking exhaust

Hello fellow Rx7s

How critical is this repair which can get very expense ($ 1200).
Should I wait until I need a new motor?

My car is about 86k miles. RPM 285,8.7, 8.8 and 8.6.
Any Suggestions.

I thank you in advance !!!
Old 06-03-06 | 02:12 PM
  #2  
93FD3S's Avatar
Big Snail
 
Joined: Dec 2001
Posts: 1,230
Likes: 3
From: San Antonio
Ok your intake manifold gasket can't be leaking exhaust gas. Its an intake manifold not an exhaust manifold. If your intake manifold is leaking, check your lower intake manifold gasket. If yours has never been changed, it probably has a paper one. The newer version is metal. If its your lower gasket its gonna be pretty labor intensive. You have to pull of your turbos to change it out. Not hard at all, just time consuming.
Old 06-03-06 | 11:38 PM
  #3  
sevensheaven's Avatar
REPU Wanter
iTrader: (1)
 
Joined: Sep 2002
Posts: 725
Likes: 2
From: Cherry Point / Havelock NC
Yes, your lower intake manifold can leak exhaust. I have two engines torn down at present and both had the old paper gasket, and both were leaking. One of them was leaking so bad that the entire rear of the engine was covered in nasty oily soot. The rear housing has a round port at the exhaust manifold that ports up to the intake lower mainfold at the rear lower corner. It has something to do with emissions and the air control valve providing air to the cat converter. See the Secondary air injection system it works with the air pump and is controled by the ECU, see service manual page F-115 in the 93 version and read the description. How much this effects the performance I don't know, but i can't image it is problem enough worth changing it.
Terry7
Old 06-04-06 | 08:54 PM
  #4  
ddkkww888's Avatar
Thread Starter
Full Member

 
Joined: Feb 2005
Posts: 113
Likes: 0
From: San Mateo, CA
Smile

Hey Gang,

Thanks for the Input!!!
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 05:40 PM
Kyo
2nd Generation Specific (1986-1992)
6
04-13-19 10:24 AM
C. Ludwig
Single Turbo RX-7's
49
01-30-19 07:31 AM
Engine stand ready
New Member RX-7 Technical
3
08-14-15 11:26 PM




All times are GMT -5. The time now is 09:27 PM.