Injector Question
12-08-07 | 10:53 AM
#26
Just order new caps from Keith. It's not hard to put them on. Once caps are on (realistically) they are junk by the time you take them off. Get new caps take the strange ones you have off and put Keith's on. A little WD40 helps them slide on easier...
Here is a picture of mine with a broken pintle cap:
12-08-07 | 02:32 PM
#29
Lives on the Forum
Joined: May 2001
Posts: 5,097
Likes: 1
From: southern NJ
Overnight is going to be a tad much IMO as well. ground should be no longer than 2 - 3 days to you. We are not opened weekends around the holiday season. Will be in monday. I will reply to your PM.
Thanks
12-08-07 | 02:55 PM
#30
Lives on the Forum
Joined: May 2001
Posts: 5,097
Likes: 1
From: southern NJ
12-08-07 | 03:58 PM
#31
Thread Starter
Rotary Enthusiast
Joined: Apr 2006
Posts: 849
Likes: 0
From: Grovetown, Ga
gotcha back, thanks.
for anyone else following this, not only was the cap too long, it was also too thick. turns out the cap was just too thick to fit into the rail, regardless of length or the extra lip. so, new pindle caps it is.
for anyone else following this, not only was the cap too long, it was also too thick. turns out the cap was just too thick to fit into the rail, regardless of length or the extra lip. so, new pindle caps it is.
12-08-07 | 05:14 PM
#32
Constant threat
Joined: Jul 2001
Posts: 4,968
Likes: 38
From: near Wichita, Kansas
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 05:40 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 04:30 PM
