Help With Stalling Issues!
#1
Junior Member
Thread Starter
Join Date: Feb 2006
Location: Las Vegas, NV
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Help With Stalling Issues!
Car starts right up, revs to about 1500 rpm, then slows and stalls. I can keep it running, but I have to barely press the gas and I can get it up to about 4000 rpm before it starts bogging down. If I try to floor it, it immediately stalls. Its slighty driveable...I can drive it, but I cant give it much gas and when I stop, it stalls again. I just recently replaced the turbos and they run fine. The problem was there before I replaced them. Ive also replaced the spark plugs. Can anyone give me some insight on what they think could be the problem? Thanks in advance!
Ben
Ben
#2
Mr. Links
iTrader: (1)
Have you:
1. Done idle adjustments using the adjustment screws on the TP?
2. Have you checked your TPS readings?
3. Have you checked the dashpot?
4. Have you checked the clutch switch?
5. Have you checked/cleaned the ISC?
6. Have you gone through the FSM troubleshooting section on stalling?
1. Done idle adjustments using the adjustment screws on the TP?
2. Have you checked your TPS readings?
3. Have you checked the dashpot?
4. Have you checked the clutch switch?
5. Have you checked/cleaned the ISC?
6. Have you gone through the FSM troubleshooting section on stalling?
#4
Junior Member
Thread Starter
Join Date: Feb 2006
Location: Las Vegas, NV
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
I also noticed that my A/F gauge showed rich while I was driving it around the block. could that be an injector prob, and what would cause it to stall when I press the gas too fast.
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
03-20-18 01:54 PM
REX7&Z32TT
New Member RX-7 Technical
5
09-09-15 05:16 AM