jza80

iTrader: (32)

Hello all,

I'm sending my fuel injectors out for cleaning since I have the fuel rail off anyway for FPD replacement. I am interested in hearing feedback on this company:

Ultrasonic Fuel Injector Cleaning Service - InjectorExperts.com

I have used FC Engineering before, and they did a good job as far as I could tell but did not include O-rings as part of the service. The company in the link states that they include new O-rings, so if this is a potential cost saving as long as the O-rings are the correct size. Has anyone used these guys? Or any other recommendations?

Thanks in advance for any comments and opinions!

Slideways FD

iTrader: (13)

I usually use rc engineering or witch hunter. They changed all the orings for me the times I had injectors cleaned.

Johnny Kommavongsa

iTrader: (13)

I just got mine cleaned by rc engineering and it came with new o rings.

Also if u need new orings, u can get them from rock auto for $3 a set.

Mahjik

iTrader: (1)

I would recommend Witch Hunter. As far as RC Engineering, I used them before as well but the o-rings they supplied were junk. I had to replace them with OEM o-rings. Many others on the forum had the same issue with the RC supplied o-rings.

jza80

iTrader: (32)

This is very helpful, thanks for all the information!

jza80

iTrader: (32)

Just wanted to follow up on this, I wound up sending my injectors to Witch Hunter. The turn around was very quick and the injectors arrived with new o-rings and new plastic tips. The flow check showed good performance before and after, but at least I know where I stand. Thanks again for the info on this company!

86boy

iTrader: (1)

I used Injector Rx located in Houston, TX for my FD injectors. They replaced everything and gave me a before/after flow sheet for the injectors. they also looked brand new when I got them back. It was around $100-120-ish shipped for all 4 injectors there and back.

https://www.injectorrx.com/