Fan issue after front mount install
#27
Passenger
Posts: n/a
I will have to find out how to test them to find out which ones are bad.
I have been using my blower fan to control the fans and it has been working great. I drove an hour and a half to orlando and back and the temps on the way there got up to 92 doing 80-85 and on the way back it got up to 89 doing some pulls with a friends 2nd gen. As soon as i got off the hiway the temps dropped back down to 83.
#29
brap brap mf
iTrader: (14)
Join Date: May 2004
Location: clifton, NJ (north jersey)
Posts: 402
Received 0 Likes
on
0 Posts
looking at the pic Karak posted, if you apply 12v+ to PIN A and Ground to PIN B if you take a voltmeter and check for continuity between PINS C and D you should have continuity. If you do not the relay is bad.
Also, when applying voltage as stated to PIN A and ground to PIN B you will hear a click.
If you dig in the FSM you can check the resistance between PIN A and B as well and compare the OHM readings with the FSM.
Also, when applying voltage as stated to PIN A and ground to PIN B you will hear a click.
If you dig in the FSM you can check the resistance between PIN A and B as well and compare the OHM readings with the FSM.
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM