ECu swap question ( replacing N3A7 with chipped N3A1)
02-27-09 | 07:11 PM
#1
Thread Starter
Senior Member
iTrader: (6)
Joined: Jan 2008
Posts: 436
Likes: 1
From: Montreal , Canada
ECu swap question ( replacing N3A7 with chipped N3A1)
i am just wondering
what would happen if i place an N3A1( non cali US ecu .. tuned by Pettit ) into my Jspec ...
i ask because Jdm`s dont have EGR amongst other things .. will the ecu whine and complain about that?
i have removed air pump , aws and most solenoids, double throttle ... and replaced them with resistors , i am running with but one error code ( Speed sensor error code becausei cut the whire so i can go over 180 km/h)
A/C works ... i have 1o2 sensor.. and of course 8bit .. which i believe the A1 is also
anyone forsees problems ?
thx
what would happen if i place an N3A1( non cali US ecu .. tuned by Pettit ) into my Jspec ...
i ask because Jdm`s dont have EGR amongst other things .. will the ecu whine and complain about that?
i have removed air pump , aws and most solenoids, double throttle ... and replaced them with resistors , i am running with but one error code ( Speed sensor error code becausei cut the whire so i can go over 180 km/h)
A/C works ... i have 1o2 sensor.. and of course 8bit .. which i believe the A1 is also
anyone forsees problems ?
thx
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
