boost issues 93
#1
Still Waiting
Thread Starter
iTrader: (10)
Join Date: May 2009
Location: Powhatan VA
Posts: 518
Likes: 0
Received 0 Likes
on
0 Posts
boost issues 93
My bf 93 rx7. mileage is 130k+
Mods:
intercooler
downpipe
midpipe
greddy muffler(entire exhaust is 4inch)
intake
bov
short shifter
radiator
no ac/heat
ast
we beleive the second turbo is toast...it smells like burning oil when it does open. usually doesnt open jerks and hesitates. Makes a whine noise too.
Well question is since the second turbo is bad would that cause the primary not to spool to 10psi? boost gauge reads 8-5-5 maybe 6.
may have few more mods-those r wht i remember.
Mods:
intercooler
downpipe
midpipe
greddy muffler(entire exhaust is 4inch)
intake
bov
short shifter
radiator
no ac/heat
ast
we beleive the second turbo is toast...it smells like burning oil when it does open. usually doesnt open jerks and hesitates. Makes a whine noise too.
Well question is since the second turbo is bad would that cause the primary not to spool to 10psi? boost gauge reads 8-5-5 maybe 6.
may have few more mods-those r wht i remember.
#3
Rotary Enthusiast
iTrader: (4)
Join Date: Jun 2007
Location: California
Posts: 1,114
Likes: 0
Received 0 Likes
on
0 Posts
Well im not really an expert, but if you hear a whining noise coming from the turbos, then i'd say it's bad. I read a thread a little while ago about another guy who was having the same whining noise from his turbo and turns out they were done.
What I would do, is either have your turbos rebuilt and balanced for about $1,500 to make them like new, or buy a used low mileage set of twins on this forum for a few hundred dollars. While you're there, might as well do a vacuum hose job with silicone hose techniques. Hope I helped
What I would do, is either have your turbos rebuilt and balanced for about $1,500 to make them like new, or buy a used low mileage set of twins on this forum for a few hundred dollars. While you're there, might as well do a vacuum hose job with silicone hose techniques. Hope I helped
#5
Full Member
iTrader: (3)
Join Date: Jan 2008
Location: Tucson, AZ
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts
I had a turbo go out on me. The turbine came off, exploded and went though the motor. Caused me to get new housing. I dont know if this is common but it did happen to me. Just so you know. Also so upgraded engine management?
#7
Full Member
iTrader: (3)
Join Date: Jan 2008
Location: Tucson, AZ
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts
What im saying is if the turbine comes out and goes though the motor it can cause you to buy new housings $720 a piece, new rotors $625 a piece, and other things that dont need to be replaced if the motor isnt destroyed. Like i said i dont know how often this happens but it did happen to me and i needed new housing tacking on $1400 to the rebuild cost.
Thread
Thread Starter
Forum
Replies
Last Post