5 min into reassembly question :)
#1
5 min into reassembly question :)
Im just now starting to put her back together from a rebuild.
Ive got rotorsports upper and lower IM's, so im swaping everything over to them. What is the sensor pictured? It doesnt fit in my new upper IM. the hole is present on my new one, and threaded, but its much too large for this sensor. ??
and whats up with the additional hole right next to it? my original IM doesnt have that hole. My car is a 95, is this maybe a 93-94 IM with more emissions stuff?
any help would be appreciated!
Ive got rotorsports upper and lower IM's, so im swaping everything over to them. What is the sensor pictured? It doesnt fit in my new upper IM. the hole is present on my new one, and threaded, but its much too large for this sensor. ??
and whats up with the additional hole right next to it? my original IM doesnt have that hole. My car is a 95, is this maybe a 93-94 IM with more emissions stuff?
any help would be appreciated!
#5
Ok I fitted the larger hole, and it's 1/2 inch. Unless there's a reason to try and find a bigger aftermarket AIT, I guess I'll just try to get a reducer fitting
I have no idea what the other hole is for yet. Is that location a good place to run anything aftermarket?
I have no idea what the other hole is for yet. Is that location a good place to run anything aftermarket?
Thread
Thread Starter
Forum
Replies
Last Post
24seven_dada
3rd Generation Specific (1993-2002)
20
11-10-18 12:03 PM
rx8volks
Canadian Forum
0
09-01-15 11:02 PM