Dashboard Light Bulb Replacement
#1
Junior Member
Thread Starter
Dashboard Light Bulb Replacement
I have my gauge cluster out to repair the odometer, so I figure I'll replace all the gauge and warning lights. I don't want to go LED, while I can find the larger bulbs which there are 4 of, I can't find the smaller bulb. After pulling on the small bulb, I'm starting to think you have to buy it with the base, so it's important to get the right one. Anyone have the number of that bulb. Also the bulb sockets are brown, blue, and black. Are the bulbs different?
#2
Eats, Sleeps, Dreams Rotary
iTrader: (4)
Since I recently went thru this when I changed out my cluster, all the little bulbs are the same. The bigger bulbs are the easy 921’s. The tiny little bulbs though.. I’ll have to take a look at the spare cluster I have. To double check the number.
#3
Junior Member
Thread Starter
Thanks Neo, I've also found the larger ones. The smaller ones, I think need to be bought with the base. I've tried to pull them out and no luck. I may have to go the LED route, unless you have a source.
Thanks, Craig
Thanks, Craig
#4
Eats, Sleeps, Dreams Rotary
iTrader: (4)
Sorry it took so long.
The bulbs do come out. Base and light are seperate.
I tried to read the lettering on the bulb as best as I can. I think you can make it out and order the right ones.
The bulbs do come out. Base and light are seperate.
I tried to read the lettering on the bulb as best as I can. I think you can make it out and order the right ones.
#5
Senior Member
iTrader: (8)
Sticky from the interior/exterior section of the forum:
https://www.rx7club.com/interior-ext...thread-834741/
I just did this and used these quantities. Went to SuperBrightLEDs.com and chose LEDs that would give me the closest to a 360deg light pattern as possible (I think for the smaller ones, they only had 270deg if I remember correctly). There are a few dull spots on the HVAC controls that I think would benefit from 1 more bulb on each dial (See David Hayes' build thread for info on that), but nothing is so dark where you can't see them at night.
https://www.rx7club.com/interior-ext...thread-834741/
I just did this and used these quantities. Went to SuperBrightLEDs.com and chose LEDs that would give me the closest to a 360deg light pattern as possible (I think for the smaller ones, they only had 270deg if I remember correctly). There are a few dull spots on the HVAC controls that I think would benefit from 1 more bulb on each dial (See David Hayes' build thread for info on that), but nothing is so dark where you can't see them at night.
#6
Junior Member
Thread Starter
Found it on Amazon, thanks for your help! Painting interior parts, replacing caps to fix the odometer, and replacing all the dash bulbs, it's taking forever.
Thread
Thread Starter
Forum
Replies
Last Post
Pete_89T2
3rd Generation Specific (1993-2002)
2
09-06-24 02:10 PM
MR_Rick
Interior / Exterior / Audio
3
06-15-11 01:18 AM