Window Trouble
#1
Junior Member
Thread Starter
Join Date: Jun 2002
Location: Dallas, Texas
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
Window Trouble
Ive got a burnt out window motor on my passenger side Is there any possible way to decouple the window from the motor and put it up by hand?
also if anyones got a Turbo 2 spoiler or rear plastic rx-7 emblems for sale or trade private message me message me on aim or ICQ!
also if anyones got a Turbo 2 spoiler or rear plastic rx-7 emblems for sale or trade private message me message me on aim or ICQ!
#4
Former Moderator. RIP Icemark.
Are you sure that the window motor is burnt out. The one that mazda uses is very bullet proof.
90% of the time its not the motor, but the switch.
90% of the time its not the motor, but the switch.
#5
Junior Member
Thread Starter
Join Date: Jun 2002
Location: Dallas, Texas
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
Its teh moor i cvna make hte switch draw current fdrom the circuiot i knwo b/c my dash iughts dim but hte window sits htere i NEED to know how to get it up w/o usig he motor
#7
Full Member
Join Date: Jun 2002
Location: ORLANDO, FL
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
the motor has a long string of plastic beads that runs through it. u can disconnect the motor & if worst comes to worst, just disassemble the little plastic circle the beads fall directly into..then push that string of beads up while at the same time pulling the glass up with your hands. then bolt it back in. it will stay up forever. hope u got a/c.
Trending Topics
#9
Has been.. hangin' around
Join Date: Mar 2001
Location: Milpitas, CA
Posts: 2,618
Likes: 0
Received 0 Likes
on
0 Posts
Goody for you and the typos, how about retype it, because I can't tell WTF you wrote!
Just take a good look at the wiring diagram, and find the red and green wires that acutate the motor (I THINK that's the color, I forget). Apply ground to one, and 12V to the other. If the window motor just makes noise but doesn't go anywhere, reverse the two wires. Zip!
And you'll know for sure if it's the motor.
However, I don't know of ANY way to manual operate the window, so good luck.
PaulC
Just take a good look at the wiring diagram, and find the red and green wires that acutate the motor (I THINK that's the color, I forget). Apply ground to one, and 12V to the other. If the window motor just makes noise but doesn't go anywhere, reverse the two wires. Zip!
And you'll know for sure if it's the motor.
However, I don't know of ANY way to manual operate the window, so good luck.
PaulC
Thread
Thread Starter
Forum
Replies
Last Post
FC3S Timmy
2nd Generation Specific (1986-1992)
16
10-03-15 01:08 AM