KillaKitiie

i was driving and suddenly my car will not shift into any gear? i checked my clutch fluid level and its full.i tried to shift it a few minutes later and it worked fine.i know its not my clutch because its dissengaging and engaging.its making a rough noise coming from under the shifter and its vibrating like something came loose please help me out?...

stainless steel clutch line
rebuilt slave and master cylineders
new clutch

Cosmo_TT

iTrader: (11)

probably your shift linkage

RotaryEvolution

iTrader: (30)

did it happen to have left side return spring and now it doesn't?

the shifter mechanism for all FC's suck *****.

KillaKitiie

is there a specific part your referring?

RotaryEvolution

iTrader: (30)

there is a centering spring from left to right and right to left, the one that pushes the shifter back from the left side tends to break.

OMEGAMANRX7

might be your clutch master cylinder, I had the same problem. Really sux

RotaryEvolution

iTrader: (30)

explain it in a little more detail, did it feel like it was stuck in any particular gear or was it grinding or trying to force the car to try and move while trying to go into gear?

could be a clutch or slave cylinder problem, only way to determine is by watching the slave cylinder pushrod while someone is pressing the pedal while this phenomenon is occurring.

KillaKitiie

ok i just got back from driving it and the problem is suddenly gone!!??? but when it happened i went to put it in first and there was a very strong force pushing back on my hand.no grinding just a wall wouldnt move any farther..i turned the car off put it in gear and then it started to grind like metal or something then nothing.it kinda started to grind a couple of times while i was driving it but it stopped and hasnt done it in about 30min.??
oh and karack i never installed that spring you were talking about.unfortanitly for me i didnt find out about it until the tranny was already in the car.oh and yea it was pushing the car while i was trying to get into gear.

RotaryEvolution

iTrader: (30)

sounds like the master cylinder bypassed temporarily but it could be an internal tranny issue, hard call to make.... if it is an n/a tranny then i would probably just drive it since you can find them locally in wrecking yards if anything does happen to be wrong with it.

KillaKitiie

it just scared the **** out of me ..ya know i only need like 50$ and i can buy all my parts for my rebuild..


i guess i havent been so good to her when i was on mazdatrix looking for the shifter boots.i read the item that said upper and lower boot kit and i bought it thinking it was all i needed.come to find out there are the little rings .. i never even knew until i read the how to install shifter on there webpage.so in a sense ive been bare balling it so shes probably mad.im going to get them tomarrow it will probably help alot.