Why a 6k wall and huge backfire?
#27
the reason i'm pissed is because you're trying to call me liar when i KNOW what i had and i know what it tested like, and it was in spec, but it was still bad. you're all the way down there in surfer land cracking coconuts with torque wrenches, i don't believe you can tell what my tps read from 3000 miles away. and just to clear up any confusion you may have had about my post when i was talking about 6k, i was talking about 6000 rpm.
#29
Originally Posted by beefhole
Probably not at idle, but it would indicate a crapped out TPS and would need to be replaced regardless.
#30
Lives on the Forum
Originally Posted by rexman13b
the reason i'm pissed is because you're trying to call me liar when i KNOW what i had and i know what it tested like, and it was in spec, but it was still bad. you're all the way down there in surfer land cracking coconuts with torque wrenches, i don't believe you can tell what my tps read from 3000 miles away. and just to clear up any confusion you may have had about my post when i was talking about 6k, i was talking about 6000 rpm.
No sense I repeat myself.
-Ted
#31
Ex-EPiK Rotary Doode
Join Date: Jan 2004
Location: Myrtle Beach, SC
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by The Spyder
All are nice and tight with screw type hose clamps. I would think it would cause other problems like a really bad idle. Im sitting at 700 right now, with a leaky oil injector spider feed (just a small one)- Just need to yank the uim and fix it.
Hurm....
Hurm....
After 3 or 4 tries at tightening it, then the engine cooling down and trying again, I finally replaced the questionable clamp and the problem went away.
If you haven't replaced your hose clamps recently you might want to take a closer look at them.
#33
Ok hurm.
I finally got around to checkin on this today. I replaced the fuel filter, only managed to down about a gallong of fuel while doing so . Got that all switched and primed. Took it for a test after it warmed up and BOOM its still there.
Soo I pulled the pressure sensor, car barly ran when I steped on it, but I managed to get it to 6k, and it wouldnt go any further.
10psi is damn fun, but what the hell is the wall comming from?
I finally got around to checkin on this today. I replaced the fuel filter, only managed to down about a gallong of fuel while doing so . Got that all switched and primed. Took it for a test after it warmed up and BOOM its still there.
Soo I pulled the pressure sensor, car barly ran when I steped on it, but I managed to get it to 6k, and it wouldnt go any further.
10psi is damn fun, but what the hell is the wall comming from?
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM