2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:

whine/squeal at high rpms?

Thread Tools
 
Search this Thread
 
Old 06-25-03, 07:10 PM
  #1  
STUCK. I got SNOWNED!!!!!

Thread Starter
iTrader: (7)
 
Terrh's Avatar
 
Join Date: Mar 2002
Location: Windsor, On
Posts: 8,722
Received 13 Likes on 9 Posts
whine/squeal at high rpms?

I've got this really weird whine/squeal type of noise at high RPM ONLY when under load.. It VERY rarely happens if the car is not under load, and it won't be nearly as bad if it does. it doesn't come at the same point always, sometimes at 4000 RPM, sometimes not till 6000.. When its happening the car doesn't seem to be as fast as it should be. The car is very torquey, and has lots of boost (usually). I've still got some minor boosting issues, but they seem to be happening less and less all the time, hopefully they just go away. The car is certianly "quick". I beat a slightly modded turbo eclipse yesterday, so it's definately not bad. Anyone know what 2nd gen eclipses run in the 1/4?


Also, I had my intercooler hoses apart yesterday and noticed a tiny bit of oil around the edges of the one seam.. is this anything to be worried about? (the amount of oil was pretty small.. 1.5ml maybe?) When turbo oil seals blow you really know it, right? The car never smokes or anything.
Old 06-25-03, 07:14 PM
  #2  
pei > caek

 
dr0x's Avatar
 
Join Date: May 2002
Location: Mars
Posts: 4,643
Likes: 0
Received 0 Likes on 0 Posts
Loose/old belts? And a little oil in IC pipes is ok. The crankcase breather vents back into the intake.
Old 06-26-03, 08:25 AM
  #3  
STUCK. I got SNOWNED!!!!!

Thread Starter
iTrader: (7)
 
Terrh's Avatar
 
Join Date: Mar 2002
Location: Windsor, On
Posts: 8,722
Received 13 Likes on 9 Posts
the belts are brand new, and I'm pretty sure they don't slip. I installed an E-Fan yesterday, and it didn't improve things, so it's not my fan.


Any other ideas?
Old 06-26-03, 04:57 PM
  #4  
STUCK. I got SNOWNED!!!!!

Thread Starter
iTrader: (7)
 
Terrh's Avatar
 
Join Date: Mar 2002
Location: Windsor, On
Posts: 8,722
Received 13 Likes on 9 Posts
bump0r
Old 06-26-03, 06:24 PM
  #5  
Full Member

 
Castrol86GXL's Avatar
 
Join Date: Apr 2003
Location: Hemet, So California
Posts: 99
Likes: 0
Received 0 Likes on 0 Posts
your water pump is going... do a clean flush and hopefully it helps it. whats happening is the belts are tryin to turn the water pump with the speed of the engine and pushing all that water and with hard calcium or rust it aint always going to turn that fast so the belts are going to brake loose like a tire does from the pavment and start squealing like a 2 cent chinese crack ***** getting a $100 tip for squealing.
Old 06-26-03, 09:53 PM
  #6  
STUCK. I got SNOWNED!!!!!

Thread Starter
iTrader: (7)
 
Terrh's Avatar
 
Join Date: Mar 2002
Location: Windsor, On
Posts: 8,722
Received 13 Likes on 9 Posts
That's an... interesting.. analogy you have there.



I'm replacing the water pump tomorrow, so we'll see if that fixes it. I hope so!

Update on it: I've gotten it to do it under load as low as 3500RPM, and when not under load.. maybe 5000?

Any ideas on why it could change while under load?
Old 06-26-03, 10:06 PM
  #7  
pei > caek

 
dr0x's Avatar
 
Join Date: May 2002
Location: Mars
Posts: 4,643
Likes: 0
Received 0 Likes on 0 Posts
New belts stretch a little. IMO its good to go back a few times and tighten them.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
Vendor Classifieds
5
08-09-18 05:54 PM
The1Sun
1st Generation Specific (1979-1985)
7
09-18-15 07:13 PM
The1Sun
New Member RX-7 Technical
5
09-15-15 04:45 PM
gxl90rx7
Haltech Forum
4
09-14-15 03:09 PM
The1Sun
1st Generation Specific (1979-1985)
0
09-07-15 10:21 PM



Quick Reply: whine/squeal at high rpms?



All times are GMT -5. The time now is 08:08 AM.