what is this stuf that holds the hood parts together? Silicone? Epoxy?
#2
it is a two part epoxy. any automotive grade will do. but the ahrd part is getting the beams to touch the underside of the hood so it will bond. What i did is put the hood upside down in the grass on a blanket. then I took 2x4s that were long enough to toutch most of the beams but short enought they didn't touch the side. then I put cender blocks on them to force the beams to touch. I let it sit there for a day and all was well.
good luck
good luck
Thread
Thread Starter
Forum
Replies
Last Post
David Hayes
3rd Generation Specific (1993-2002)
13
09-05-22 12:45 PM