What custom parts would you like to see made for the FC
#6
Lambo door kit maybe? 5 mm rotors. after market back seat conversion kit... MAP sensor conversion kit, 5 lug conversion kit, stronger door handles (some guys know what I mean about that) 20B conversion kit of course, a good repair kit for my sunroof thats retarded to open/ or I'm just too lazy to research the fix and tear it all apart (which takes forever) and really fix it, There's lots of stuff I wish was after market that I didn't have to get directly from Mazda but thats all that comes to mind at the moment
Trending Topics
#17
Senior Member
![](https://www.rx7club.com/images/misc/05_year_icon.png)
iTrader: (1)
Join Date: May 2006
Location: southern indiana
Posts: 363
Likes: 0
Received 0 Likes
on
0 Posts
a adapter for 2 13bs to sit side by side to hook up to 1 trany.....would be sweet =) a 4 rotor for half the cost
or adapter for a flat 4 to a 13b trany would make for a lighter car, lower cg and u could still get 300 hp and cost of a rebiuld would go from 1000+ to 400 bucks
or adapter for a flat 4 to a 13b trany would make for a lighter car, lower cg and u could still get 300 hp and cost of a rebiuld would go from 1000+ to 400 bucks
Last edited by mightymite; 02-11-08 at 04:34 AM.
#22
bad idea. i'd rather not hack up my roof just to save a few pounds and compromise structural integrity. unless u mean just a cf cover for the whole damn thing
#23
Engine, Not Motor
![](https://www.rx7club.com/images/misc/15_year_icon.png)
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 110 Likes
on
93 Posts
I don't mean to be a pessimist, but these topics come up often and nothing ever comes of them. Not a single one of these has produced any products for our cars EXCEPT when the thread has been started by an established vendor.
The market is too small, most people aren't willing to pay reasonable prices, and the original poster always underestimates the amount of effort required.
The market is too small, most people aren't willing to pay reasonable prices, and the original poster always underestimates the amount of effort required.
#24
Inexperienced Tinkerer
Join Date: Mar 2007
Location: Sanford, NC
Posts: 397
Likes: 0
Received 0 Likes
on
0 Posts
aaron's right, but i still like to read what everyone else would want if they had their way ![Wink](https://www.rx7club.com/images/smilies/wink.gif)
AFM->hot wire MAF conversion kit (to eliminate that ugly huge AFM unit, heh), newer-style door handles that pull out instead of lift up (the stock unit size may be too small, though)
![Wink](https://www.rx7club.com/images/smilies/wink.gif)
AFM->hot wire MAF conversion kit (to eliminate that ugly huge AFM unit, heh), newer-style door handles that pull out instead of lift up (the stock unit size may be too small, though)