waterpump housing question
12-31-06, 01:14 AM
#2
W. TX chirpin Monkey
Join Date: Sep 2001
Location: Mesquite, TX
Posts: 2,684
Likes: 0
Received 0 Likes
on
0 Posts
the pump itself is no issue. I don't recall the pumps being different for TII or N/A. However the front cover plates differ from S4-S5 and you have to make sure they don't rub,or you WILL crack your front cover plate. I have a S5 waterpump and housing on a S4 front cover. The housing had to be ground down on one area, and it clears.....but barely. I've found this out the hard way.
12-31-06, 05:29 AM
#3
Full Member
Thread Starter
Join Date: Jul 2006
Location: kodiak
Posts: 232
Likes: 0
Received 0 Likes
on
0 Posts
yup that is the reason y i am asking because i have the s4 front cover on the s5 block and the s5 wph rubs on the front cover...thats y i am making sure if the na s4 wph would work on the s5t2 block...
12-31-06, 06:01 PM
#7
if you have a turbo you will need the turbo housing... if you have a non turbo then you can use the turbo housing, you just need to block it off with a short peice of hose and a bolt
here is some reading for you
https://www.rx7club.com/showthread.p...r+pump+housing
https://www.rx7club.com/showthread.p...r+pump+housing
here is some reading for you
https://www.rx7club.com/showthread.p...r+pump+housing
https://www.rx7club.com/showthread.p...r+pump+housing
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
cdn
2nd Generation Specific (1986-1992)
14
09-10-15 06:23 AM
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM
cdn
2nd Generation Non-Technical and pictures
0
08-11-15 08:59 PM