Tryied replacing clutch in my garage and i have failed
#26
Rotaries confuse me
iTrader: (7)
Originally Posted by staticguitar313
clutch is aligned, splines just dont want to go in, its pissing me off, i'm weak aaron so lifting it into place doesnt seem like a safe option, especially when the car is on jackstands, scares the pissoutta me being under there altough i do have the car firmly supported by the rails
#27
dAracIngPhaRmaCist
Join Date: Mar 2004
Location: Fort Lauderdale
Posts: 877
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Aaron Cake
I normally install the transmission by getting under the car with the transmission on my chest. I bench press the bellhousing into place while supporting the tail section with my feet. A little bit of rotation and wiggling and it falls into place after about 10 minutes of swearing.
#29
I helped one of my buddies swap out a tranny in his S4, we made a tranny jack out of a skateboard and 2 jacks. Bolted the jacks to the skateboard, and rolled it into place, jacked the tranny up and pushed it onto the engine. It did take like 10 minutes to get past the 1" mark, it probably would have helped i knew to tilt the engine back
#30
Rotaries confuse me
iTrader: (7)
Originally Posted by gxl90rx7
I helped one of my buddies swap out a tranny in his S4, we made a tranny jack out of a skateboard and 2 jacks. Bolted the jacks to the skateboard, and rolled it into place, jacked the tranny up and pushed it onto the engine. It did take like 10 minutes to get past the 1" mark, it probably would have helped i knew to tilt the engine back
Thread
Thread Starter
Forum
Replies
Last Post
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM