tempature problem ..
#1
Junior Member
Thread Starter
iTrader: (2)
Join Date: Dec 2008
Location: San Diego, CA
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
tempature problem ..
so i just changed the thermostat n hoses on my car .. and now the temperature wont even reach a quarter .. i think since its not hot enough .. cuz when i try n redline its not smooth in second gear it kinda studders .. noob help sorry n sorry again if this is a repost i searched =X
#7
Junior Member
Thread Starter
iTrader: (2)
Join Date: Dec 2008
Location: San Diego, CA
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
so i checked if it was upside down and it wasnt .. do thermostats have to be broken in ? cuz today it was pretty hot out n my car finally reached a quarter n a lil bit higher .. but went back down after freeway driving .. anymore suggestions ? its still around 1/5 of the temp gauge tho .. when i drive around
Trending Topics
#8
Parts collector
iTrader: (4)
As Felix mentioned, don't redline the engine unless you're warmed up.
Man, the only way you're going to get a good reading is installing an aftermarket temp gauge. The stock gauge is notoriously inaccurate and comparisons between cars is suspect at best. While yours sits around 1/5, mine sits closer to 1/3. If you really want to know exactly what your temps are.... get another gauge.
Man, the only way you're going to get a good reading is installing an aftermarket temp gauge. The stock gauge is notoriously inaccurate and comparisons between cars is suspect at best. While yours sits around 1/5, mine sits closer to 1/3. If you really want to know exactly what your temps are.... get another gauge.
#10
First time rx7 *****
Join Date: Jan 2009
Location: maple ridge
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
GET AFTERMARKET GAUGES, by the time my stock gauge says the cars fully warm, my water temp and oil temp having even started to move yet, takes another 5-10 minutes.
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
1st Generation Specific (1979-1985)
7
09-18-15 07:13 PM