strong bouncing idle after hard pull ping rich
06-09-10, 01:07 PM
#26
Junior Member
Join Date: May 2010
Location: Seattle, WA
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
never had a bouncing idle caused by anything but a TPS( 10% of the time), or a vacuum leak(90% of the time). sounds like boost blew a line or a nipple off.
do you have paper or metal intake gaskets?( or maybe just silicon?)
Paper or silicon, i would check there also. or do a intake pressure test, as these dont seem to expensive to get the parts to do. just some homedepot fittings, guage, and some soap and water.
do you have paper or metal intake gaskets?( or maybe just silicon?)
Paper or silicon, i would check there also. or do a intake pressure test, as these dont seem to expensive to get the parts to do. just some homedepot fittings, guage, and some soap and water.
06-10-10, 10:28 AM
#28
A pulsing idle is typically a vacuum leak, a few things to check:
Throttle cable for seizing, needs to returning completely
Turbo inlet duct for cracks
All couplers and clamps on intercooler
BOV for leaks, especially if it is aftermarket
Check your boost sensor, if the voltage is screwy it can tell the ECU all kinds of bad info
Throttle cable for seizing, needs to returning completely
Turbo inlet duct for cracks
All couplers and clamps on intercooler
BOV for leaks, especially if it is aftermarket
Check your boost sensor, if the voltage is screwy it can tell the ECU all kinds of bad info
06-10-10, 11:18 AM
#29
brap-brap-brap
iTrader: (1)
Join Date: Mar 2004
Location: Los Angeles, CA
Posts: 287
Likes: 0
Received 0 Likes
on
0 Posts
bouncing idle can be vacuum leak. one reason its more likely a vacuum leak instead of a tps: it started after you did a hard pull.
im going to guess that boost pressure blew off a vacuum line.
im going to guess that boost pressure blew off a vacuum line.
Thread
Thread Starter
Forum
Replies
Last Post