2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:

smoking 86

Thread Tools
 
Search this Thread
 
Old 10-14-04, 04:06 PM
  #1  
Full Member

Thread Starter
 
rockman7's Avatar
 
Join Date: Sep 2004
Location: Fresno, CA
Posts: 121
Likes: 0
Received 0 Likes on 0 Posts
smoking 86

smoke cloud puffs out of pipe. like its burning gas, also heard 86 injecters leak when vehicles off... smoke only comes out at around 6-7t rpm. maybe apex seals??? 166,886 mi. on motor..
Old 10-14-04, 04:51 PM
  #2  
Locust of the apocalypse

 
YearsOfDecay's Avatar
 
Join Date: Apr 2003
Location: Directly above the center of the earth (York, PA)
Posts: 2,553
Likes: 0
Received 1 Like on 1 Post
Not likely apex seals.... rotor oil rings more likely.

if it was the apex or the side seals, your idle would be **** and it would run like ***!!

Time for a rebuild.. but i've seen N/A's run like that for a good while before puking... problem is, the longer you delay, the more likely a REALLY bad thing could happen and waste the motor.

Make sure you change your oil about ever 1500 miles. as the oils viscosity breaks down from heat and friction (lots of those in a 13b) it will actually get thinner and the car will smoke more.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
17
06-03-24 03:25 PM
mulcryant
General Rotary Tech Support
5
10-04-15 12:18 AM
rx7inoregon
Old School and Other Rotary
5
10-01-15 12:44 PM
frosty1993
General Rotary Tech Support
3
09-30-15 01:27 PM
dexter snoek
New Member RX-7 Technical
4
09-29-15 09:18 AM



Quick Reply: smoking 86



All times are GMT -5. The time now is 01:42 PM.