RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   2nd Generation Specific (1986-1992) (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/)
-   -   six speed? (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/six-speed-134616/)

'Vert in Vegas 11-21-02 08:47 AM

There is a company making adapters to use the T56 6 speed from a Camaro.

Jimmy325i 11-21-02 09:57 AM

Presetlimits,

I think you are an idiot for telling me the obvious. I try very hard not to flame people here, but you've pissed me off.

Fifth gear is overdrive. Duh! What do you think overdrive means? Any gear ratio that makes the final drive side of the gearbox spin faster than the input side is an overdrive. I like my overdrive. I would be deaf without it! My proposal is for TWO, count em 2! Overdrive gears that would leave the stock lower ratios intact and make the stock 5th gear ratio usable as a power gear if someone (like me!) would want to do so. Do you leave your car in second because that is where the powerband is while cruising at 35mph? I know I sure don't. I use 4th or 5th depending on how slow traffic around me is. This would not change if there was another gear in there to choose from other than I might chose my "new" fifth gear rather than bog the engine in the stock 5th gear ratio which would now be 6th.

My proposal would allow for a 15% overdrive to bridge the gap between 4th and 5th. This new lower gear in between the two stock ratios would allow for those of use who like exceeding 140mph to do so more easily. You say there's no need? Well, you don't drive like I do.

Also, there is a custom driveline shop in the Twin Cities metro area (here in MN) that will build you custom driveshafts for less than $200. I've had several made for my trucks over the years. Maybe you just don't know where to look for what you need.

FPrep2ndGenRX7 11-21-02 10:10 AM

http://www.gurumotorsports.com/

Check out the trans in the products section.

presetlimits 11-21-02 10:52 AM

ok mr. jimmy, im an idiot im sorry, dont flame me..shut your trap

Jimmy325i 11-21-02 11:46 AM

GTUs have OD too. ;)

ZachSpazz 11-21-02 12:07 PM

Couldn't you guys just use a Miata tranny? I'm not sure if the bellhousing would match up, but I do know that Pineapple can put Miata gears into an RX-7 tranny case.

Some Miatas came 6-speed as well...

slinges 01-23-03 04:27 PM

Now there's an idea. Anybody have thoughts on that one?

OC_ 01-23-03 05:23 PM

is that guru and hks box syncroless? might be able to perform a clutchless shift with these suckers, just blip the throttle and thow it into gear! ( crashbox?)

OC_ 01-23-03 05:34 PM

ooh! i was just doing some searching on racing crashbox trannys. Info seems really hard to find, but i found this.

" You can shift without the clutch in a modern production car transmission, but it's not good for it.

There are two reasons for shifting without the clutch in a race car with a modern racing gear box (non-synchro). On upshifts, it is slightly faster to shift without the clutch, meaning slightly lower lap times. It also allows left foot braking, which eliminates the delay of moving your foot from the gas pedal to the brake pedal, again lowering lap times and improving car
control.

This eliminates the need for double clutching, since you don't use the clutch on upshifts or downshifts."

slinges 01-26-03 01:53 AM

bump it

Liquid Anarchy 01-26-03 02:02 AM

I've been looking into the 99+ Miata Transmissions, and w/ the FC bellhousing, it bolts right up. All I need to do is talk to some performance miata people, see what kind of HP they can handle, and figure where the shifter would sit...

j200pruf 01-26-03 02:30 AM

Damn witha Miata 6 speed on a RX7 you would be shifting a lot more, but it seems like it would be kewl, but maybe keeping the stock 1st-3rd. Don't realyl know a lot about gearing but this seems right to me any suggestions?

Liquid Anarchy 01-26-03 02:34 AM

Tearing into a transmission and switching gears isn't a job, suited for the every-day mechanic. Moreover, the 99+ 6-speed isn't made by the same company as the Miata 5-speed. The only reason I suggest this might work is, the RX-7 5-speed bolts right into the Miata by swapping the bellhousing. If that's the case, then anything that swaps onto the Miata, should be able to go on the RX-7 just the same.

bingoboy 01-26-03 02:38 AM

doesn't scathcart run a 6speed in his turbo?

j200pruf 01-30-03 12:19 AM

Any news Liquid?

HWO 01-30-03 02:49 AM

[QUOTE]Originally posted by Evil Aviator
[B]http://www.conversioncomp.co.nz/mazdarx7.htm

[QUOTE]

strange u should mention that, those a W55 and W57 gearboxes not the Getrag 6 speed. we sell alot of W55 and T50 gearboxes to that guy from where i work, you'll be freaking amazed at what he buys the boxes for compared to what he sells them for.........

1FastT2 01-30-03 06:44 AM

Im not sure if this was mentioned earlier. Why dont you guys just wait for the Rx-8 to come out. It will be equipt with a 6 speed that looks like it will just bolt in. Im sure it wont take too long after they come out that someone wrapes theirs around a tree.

Jimmy325i 01-30-03 08:50 AM

Supra trannies are still 2600 bucks used when you can find one. How much you think that rx-8 tranny's gonna run being the first one in the boneyard?

We need to find a cheaper solution other than waiting another decade for the availibility and prices to improve.

slinges 01-30-03 09:42 AM

I realize that this isn't a real solution, because it still leaves you with a 5-speed, but I figured out that if you take the gears from a miata 6-spd, and put gears 1-3 and 5-6 in the RX-7 bellhousing, you'd have a pretty sweet transmission. The gear ratios are really low, if that's what you're looking for. Just a thought...I'd still like to have 6 gears instead of 5, so keep thinking....

Terrh 01-30-03 10:50 AM

custom trannies = NOT cheap
the HKS dogmission is probably the cheapest and best aftermarket transmission for the rx-7... I think Quafie makes one (or will make one), but the price is in the 20s... transmissions ain't cheap.

I do really like the idea of the miata 6spd, and it should come reasonably close to bolting in... Just swap the bellhousings, and have a custom driveshaft made.... But is it strong enough for a highly modded n/a ? It's probably nowhere near strong enough for even a stock TII, they just make WAY too much torque. Miatas are pretty revvy, so the transmission is probably OK for extended high rpm usage (on your much loved 140+mph runs... hehe)... why doesn't someone go and check this out? junkyard miatas seem to be relatively abundant.... The only thing I worry about again, is can the tranny handle 160-180HP?

slinges 01-30-03 11:10 AM

Flyin' Miata routinely runs 250+ whp in their miatas, and I THINK all they have is upgraded clutch, etc.

However, I was told that the 6-speed Miata does not have a removable bell housing. I suppose it wouldn't hurt to get one to look at; you can always sell it again.

Stephen

Fitness Stain 01-30-03 11:12 AM

how often do GTUs tanny's come up...
it would be sweet if 5th gear was just like anyother gear...and how much do they run in good condition

KNONFS 01-30-03 11:19 AM


Originally posted by Jimmy325i
Presetlimits,

I think you are an idiot for telling me the obvious. I try very hard not to flame people here, but you've pissed me off.

That is NOT a good response nor a way to treat a Rx7 peer. This is not the Supra Forum!!!

:mad:

banzaitoyota 01-30-03 11:23 AM

Due to the Childish acts exhibited in this thread I will not share the info on my miata geared tranny from Pineapple Racing

slinges 01-30-03 11:29 AM

Please? Don't let the poopheads ruin it for everyone!


All times are GMT -5. The time now is 02:52 PM.


© 2024 MH Sub I, LLC dba Internet Brands