seat back trim
#1
I'll have a Coke!
Thread Starter
seat back trim
hey all,
I'm looking to replace the torn seat back on my '91 coupe. I'm looking to order this piece from mazdaformance but the only problem is it says it's for the passenger side.
Could somebody tell me if this will fit the driver side which is the one I'm trying to replace. There is the adjustable lumbar support **** on the drivers side but I don't see that being a problem. The parts diagram says that they are the same but you know how accurate that thing is.
I have a picture of the spot on my site, check my sig for the link.
I'm looking to replace the torn seat back on my '91 coupe. I'm looking to order this piece from mazdaformance but the only problem is it says it's for the passenger side.
Could somebody tell me if this will fit the driver side which is the one I'm trying to replace. There is the adjustable lumbar support **** on the drivers side but I don't see that being a problem. The parts diagram says that they are the same but you know how accurate that thing is.
I have a picture of the spot on my site, check my sig for the link.
#4
Former Moderator. RIP Icemark.
No, the drivers and passengers side are different in the GXL/vert packages.
The problems you would run into would be that the hole for lumbar would be in the wrong place and the seat sides are slightly different (slightly more cushion on the inside edge), as well as the lower section where the upper frame meets the lower frame would not be covered correctly (again holes and re-enforced panels locations).
The problems you would run into would be that the hole for lumbar would be in the wrong place and the seat sides are slightly different (slightly more cushion on the inside edge), as well as the lower section where the upper frame meets the lower frame would not be covered correctly (again holes and re-enforced panels locations).
Thread
Thread Starter
Forum
Replies
Last Post