school me on street porting
01-19-11 | 08:07 PM
#26
yeah those are the same templates i used.
I believe i got my carbide bits from an online drill-bit shop. Price wasnt to bad. I'll sift through my stack of receipts that I keep, there's probably an invoice in there. I'll let you know.
I believe i got my carbide bits from an online drill-bit shop. Price wasnt to bad. I'll sift through my stack of receipts that I keep, there's probably an invoice in there. I'll let you know.
01-19-11 | 08:19 PM
#27
found it lol... BuyDrillBits.com
3/8 CYLINDRICAL BALL NOSE CARBIDE BURR worked pretty well for me
http://buydrillbits.com/products/burrs.php
And grab some of these for your die grinder too: http://www.harborfreight.com/52-piec...set-96826.html
They sell smaller/cheaper sets of them in the store. (just dont press too hard cuz the shafts tend to break)
3/8 CYLINDRICAL BALL NOSE CARBIDE BURR worked pretty well for me
http://buydrillbits.com/products/burrs.php
And grab some of these for your die grinder too: http://www.harborfreight.com/52-piec...set-96826.html
They sell smaller/cheaper sets of them in the store. (just dont press too hard cuz the shafts tend to break)
01-20-11 | 10:13 AM
#28
Engine, Not Motor
iTrader: (1)
Joined: Feb 2001
Posts: 29,793
Likes: 119
From: London, Ontario, Canada
Now I also read about doing it with a dremel. I have one of the $80 variable speed dremels that I used when i modded and shaved the tb. Will that work? i read somewhere about someone using a dremel but the dremel failing while doing it. So Aaron, I can just get away with using a dremel?
01-20-11 | 10:20 AM
#29
Thread
Thread Starter
Forum
Replies
Last Post
