S5 fenders on a S4
03-07-03, 11:05 PM
#3
Driving RX7's since 1979
iTrader: (43)
Join Date: Aug 2001
Location: So Cal where the OC/LA/SB counties meet
Posts: 6,096
Likes: 0
Received 9 Likes
on
9 Posts
The only major difference is the molding.
Jerry,
Were you able to install the S5 press in connectors for the S5 molding onto the S4 fender? Or, did you have to resort to just using double stick tape?
Were you able to install the S5 press in connectors for the S5 molding onto the S4 fender? Or, did you have to resort to just using double stick tape?
03-08-03, 01:03 PM
#4
I used Permatex Black silicone adhesive sealant. Just had to cut off the clips on the back of the S5 molding. The portion of the fender in front of the wheel well has the holes, so the front piece with the marker light goes in fine, but behind the wheel well there is no holes.
The other minor issue was that the S4 fender has no "provision" for the S5 air skirt. The S5 fender has a gets a little wider for the skirt to bolt up to. It fits snug so I'm not worried about it.
The other minor issue was that the S4 fender has no "provision" for the S5 air skirt. The S5 fender has a gets a little wider for the skirt to bolt up to. It fits snug so I'm not worried about it.
