rough idle until clutch depressed
#1
rough idle until clutch depressed
if you have seen my build thread "project vivian," you would know that i have been building my 89 vert from the ground up. everythings been going pretty smooth, until i went to change my stock, broken mounts, for delrin ones from re-speed. now heres the problem, ever since i did that, my idle lumps around, or stays at 1k-1200 rpm, until i depress the cluth, and then it drops down quite a bit, to around 500 rpm. only happened after the mounts. wtf? anyone had this happen?
at this point in time, i cant get my car to idle at all, and im getting **** poor gas milage, so im replacing the tps and getting rebuilt injectors.
someone wanna help me out?
at this point in time, i cant get my car to idle at all, and im getting **** poor gas milage, so im replacing the tps and getting rebuilt injectors.
someone wanna help me out?
#2
Moderator
iTrader: (1)
Seems like w/the clutch depressed there is more load on the engine and the BAC ought to compensate for this and prevent the idle speed from dropping so much. Also, the charging voltage probably drops as well when the idle speed falters and this could cause a rough idle perhaps. And look for vacuum leaks as well.
#3
ok, there are no vacuum leaks, but ill spec out the bac and see whatsup with it, i have a spare engine with all the bits on there.
hopefully i can get this fixed, cause i look like an idiot sitting in traffic with the idle constantly hunting...
Lloyd
hopefully i can get this fixed, cause i look like an idiot sitting in traffic with the idle constantly hunting...
Lloyd
Thread
Thread Starter
Forum
Replies
Last Post
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM
83revival
New Member RX-7 Technical
4
09-03-15 10:42 PM