Removing cold start...
08-14-02, 08:24 PM
#1
Enemy Combatant
Thread Starter
Join Date: Apr 2002
Location: Guelph, Ontario
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
Removing cold start...
I have picked up a cruise control from a junkyard run, and thought that I may as well remove this waste of space that is the cold start bottle.
Now my question is how does one go about doing this so it won't need to be hooked back up again? Does anyone have a link to a page with a how-to on this subject?
Now my question is how does one go about doing this so it won't need to be hooked back up again? Does anyone have a link to a page with a how-to on this subject?
08-14-02, 11:17 PM
#3
Enemy Combatant
Thread Starter
Join Date: Apr 2002
Location: Guelph, Ontario
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
Nickname, man. Parents are Swedish, but I'm Canadian born. (Although I think an S80 would look good in my garage)
Anyone have anything related to my problem?
Anyone have anything related to my problem?
08-14-02, 11:37 PM
#4
Full Member
Join Date: May 2002
Location: New Jersey
Posts: 179
Likes: 0
Received 0 Likes
on
0 Posts
Have you ever seen sheep in the big city. I think its either UK or Canadian. But they always rant on Swedes. They have an entire segment designated to rambling swede. Its hillarious. Check it out sum time. its on after G.I joe on cartoon network. 1:30-Gi Joe 2:00 Sheep both times are A.M
08-15-02, 07:35 AM
#5
Enemy Combatant
Thread Starter
Join Date: Apr 2002
Location: Guelph, Ontario
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
I've never seen it, though when I was driving through Norway, there were tons of sheep, even in Lillihammer, there were sheep around. Maybe I'll have to check Gnucleus for episodes...
08-15-02, 07:39 AM
#6
Senior Member
Join Date: Jul 2001
Location: Havre de Grace, MD
Posts: 576
Likes: 0
Received 0 Likes
on
0 Posts
a little more on topic...
I removed mine and just made sure all the hoses were capped to avoid vac leaks. I dont' think it caused any problems for me (though I seem to remember it starting a little rougher, but it might have been due to something else) It was a while ago, but I remember it was pretty damn easy. good luck
I removed mine and just made sure all the hoses were capped to avoid vac leaks. I dont' think it caused any problems for me (though I seem to remember it starting a little rougher, but it might have been due to something else) It was a while ago, but I remember it was pretty damn easy. good luck
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
09-11-15 03:29 PM
risingsunroof82
1st Generation Specific (1979-1985)
8
09-07-15 01:11 PM