Rebuild tool Question.
#1
Full Member
Thread Starter
iTrader: (2)
Join Date: Feb 2008
Location: Rohnert Park, CA
Posts: 212
Likes: 0
Received 0 Likes
on
0 Posts
Rebuild tool Question.
im about to do a rebuild tomorrow and was wondering if i will need the..pilot bearing puller, stud puller and the alignment dowel puller?... are they really necessary can i use something else or can i pick them up at like a pep boys or something.
#2
Mike Honcho
Join Date: May 2007
Location: des moines iowa
Posts: 321
Likes: 0
Received 0 Likes
on
0 Posts
you will need a pilot bearing puller, but i use a set of vice grips for the dowels, and 2 nuts for pulling studs, just put 2 on there tighten them together and turn the bottom one and the stud comes out
Thread
Thread Starter
Forum
Replies
Last Post