rats nest on s/5 confuses me... s/4 was a breeze
03-01-05, 02:53 PM
#1
1.3L is not that small
Thread Starter
rats nest on s/5 confuses me... s/4 was a breeze
ok i am thinking of how to remove the rats nest on a S5 n/a....
on my s/4 n/a i am left with 3 vaccum lines after rats nest removal
1. pressure sensor to manifild
2. FPR to Tb nipple
3. nipple on block to TB nipple
now the S5 i have to mess with the vdi and acv, what i was thinking about was doing the air pump mod to activate the acv lines.. (you know tap a line onto the air pump line into the 5th and 6th port lines and 3ps will open them) so does this eleminate the acv? and what the hell do i do with the VDI? basically i want to rid all the vac lines i can like i did on my s4 but im confused as to what im left with on the s5... if somebody could just tell me what im left with at the end of doing this i can then figure out what to cap and what to run vac sources too... thanks in advance
christopher
on my s/4 n/a i am left with 3 vaccum lines after rats nest removal
1. pressure sensor to manifild
2. FPR to Tb nipple
3. nipple on block to TB nipple
now the S5 i have to mess with the vdi and acv, what i was thinking about was doing the air pump mod to activate the acv lines.. (you know tap a line onto the air pump line into the 5th and 6th port lines and 3ps will open them) so does this eleminate the acv? and what the hell do i do with the VDI? basically i want to rid all the vac lines i can like i did on my s4 but im confused as to what im left with on the s5... if somebody could just tell me what im left with at the end of doing this i can then figure out what to cap and what to run vac sources too... thanks in advance
christopher
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
17
06-03-24 03:25 PM
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM
FC3S Timmy
2nd Generation Specific (1986-1992)
8
10-02-15 08:08 AM