Quick Help Plz
#1
Senior Member
![](https://www.rx7club.com/images/misc/05_year_icon.png)
Thread Starter
Join Date: Oct 2006
Location: Tennessee
Posts: 493
Likes: 0
Received 0 Likes
on
0 Posts
![Exclamation](https://www.rx7club.com/images/icons/icon4.gif)
Unflooding, take out all 4 or bottom 2 plugs? crank it over with gas to the floor?
OR use the ATF in the bottom 2 plug holes? and take out the EGI??
Or just pull the plugs and crank it over?
i need this done ASAP i got to have my car running before midnight. work at 1am
OR use the ATF in the bottom 2 plug holes? and take out the EGI??
Or just pull the plugs and crank it over?
i need this done ASAP i got to have my car running before midnight. work at 1am
#2
Former Moderator. RIP Icemark.
don't pull any plugs unless you have the motor radically flooded.
To clear the flood, simply hold the throttle all the way down without pumping it all while trying to start with the key.
If that doesn't work you can pull the EGI fuse and crank for 15 seconds, then put the fuse back in and try starting again.
All this is covered in the FAQ for FC sticky thread found at the top of this section. Always read the FAQ for FC sticky thread befo posting as it covers many of the commonly asked questions such as the one this thread was started with.
To clear the flood, simply hold the throttle all the way down without pumping it all while trying to start with the key.
If that doesn't work you can pull the EGI fuse and crank for 15 seconds, then put the fuse back in and try starting again.
All this is covered in the FAQ for FC sticky thread found at the top of this section. Always read the FAQ for FC sticky thread befo posting as it covers many of the commonly asked questions such as the one this thread was started with.
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
09-30-15 08:13 PM