Question about housings
#1
Canadian Boost
![](https://www.rx7club.com/images/misc/15_year_icon.png)
Thread Starter
iTrader: (3)
Join Date: Nov 2005
Location: Ottawa, Canada
Posts: 868
Likes: 0
Received 0 Likes
on
0 Posts
Question about housings
the question is basically whether or not it is good to interchange housings on a motor?
I bought the motor a little while back and looking at it the other day, it looks like the housings dont match. My front housing looks like a-spec s4 and rear is s5 or some kind of combo, aspec with jspec. I was told that it might interfere with the firing of the spark plugs b/c the spark plug hole could be slightly off.
From what i can tell just looking at them is that the front housing is smooth at the bottom where it kicks out and meets the oit pan. My rear housing has a raised line accross it. ( maybe some one knows them by physical description.
Any insight on the situation ?!?!?
I bought the motor a little while back and looking at it the other day, it looks like the housings dont match. My front housing looks like a-spec s4 and rear is s5 or some kind of combo, aspec with jspec. I was told that it might interfere with the firing of the spark plugs b/c the spark plug hole could be slightly off.
From what i can tell just looking at them is that the front housing is smooth at the bottom where it kicks out and meets the oit pan. My rear housing has a raised line accross it. ( maybe some one knows them by physical description.
Any insight on the situation ?!?!?
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
cdn
2nd Generation Specific (1986-1992)
14
09-10-15 06:23 AM
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM
cdn
2nd Generation Non-Technical and pictures
0
08-11-15 08:59 PM