I have decided to put cutouts on my exhaust systems, and just have a few questions...

I have an NA, where would be the best place to make the dumb tube? And has anyone else done this?

 

what are these? got a pic or a link?

 

http://www.quicktimeperformance.com/qtec.htm

I think its a much better and much affordable route than an aftermarket exhaust system.

Get the power and loudness when you need it, Get the quiet and law-abideness when you don't.

 

I have seen these things before.

I wouldn't use them at all on any rotary.

It will NOT be better than an aftermarket exhaust. It will make more power though. Another consideration is your auxilary ports. They will not function when that thing opens up. and wiring them open is not a good idea for low end.

Over all I would say don't buy it. But if your going ahead with it anyhow try to put it as far away from the engine as possible so it doesn't melt.

 

Buy them, then when you dont like them, send them to me so I can put them on the Trans Am, Im getting tired of having to get under the car to cap my cut out

 

No sir, I don't like it, and it is not even cheap rither. That money will buy you a nice race pipe right there.