Pressure Sensor vac line....
09-02-06, 03:30 PM
#1
- Make Haste -
Thread Starter
Join Date: Apr 2005
Location: Calgary, Alberta
Posts: 1,648
Likes: 0
Received 0 Likes
on
0 Posts
Pressure Sensor vac line....
I remember hearing or been told that this line that branches off of the vacuum line tree should be as short as possible....
is this true?, mine's rather long and dangles all over....
if i didnt explain it properly, it's the pressure sensor on the left side of the engine bay if your looking at the engine with the hood up....
is this true?, mine's rather long and dangles all over....
if i didnt explain it properly, it's the pressure sensor on the left side of the engine bay if your looking at the engine with the hood up....
09-02-06, 04:07 PM
#2
Yeah, I dunno man. Mine pretty much goes everywhere too. I figure the most important lines are the FPR and the pressure-sensor, so I have those be the "straight-shot" ones. However, the boost gauge and BOV lines are both tapped into that vac. source as well.
Just make 'em as short and straight-forward as possible.
Just commonsense I guess.
Just make 'em as short and straight-forward as possible.
Just commonsense I guess.
Thread
Thread Starter
Forum
Replies
Last Post
troym55
3rd Generation Specific (1993-2002)
23
05-25-16 12:42 PM
t-von
3rd Generation Specific (1993-2002)
9
09-10-15 01:56 PM