pressure sensor/sixports
08-31-03, 11:37 AM
#1
Full Member
Thread Starter
Join Date: Jan 2002
Location: sc
Posts: 131
Likes: 0
Received 0 Likes
on
0 Posts
pressure sensor/sixports
on a 88 na vert ,could removing the vaccum line from the pressure sensor and putting it back on a couple of times and also pushing and pulling on the sixport shaft while you rev the engine up cause it to mess up ? if so how and how do i it fix it now. that is what i did and now it is hard to start and won't idle under 1000k and acts like it only running on one spark plug. i feel like I AM the most stupid person in the world now and i need to have somebody kick my#$$%.
09-02-03, 11:36 AM
#3
Senior Member
Join Date: Apr 2001
Location: Dublin, VA
Posts: 593
Likes: 0
Received 0 Likes
on
0 Posts
Very unlikely unless you bent the shaft or something serious inside the intake.
I unplugged the vac line to the pressure sensor before. Even ran it that way for a week. Doubt that would cause any problems.
Check the wiring and make sure you didn't unplug something. The TPS wires are near there. That seems more likely.
I unplugged the vac line to the pressure sensor before. Even ran it that way for a week. Doubt that would cause any problems.
Check the wiring and make sure you didn't unplug something. The TPS wires are near there. That seems more likely.
Thread
Thread Starter
Forum
Replies
Last Post
alexdimen
3rd Generation Specific (1993-2002)
20
10-23-15 01:50 PM
t-von
3rd Generation Specific (1993-2002)
9
09-10-15 01:56 PM