Hi everyone,

I finally decided to mod the switch as shown in the archives, thread linked below:

https://www.rx7club.com/2nd-gen-archive-72/heavy-duty-light-switch-operation-how-too-prevent-burnout-164931/

I am posting a picture on how I intend to wire in a relay as described in the thread above. Did I get this right, and/or is there a better way? Should I tie into the factory wiring for the ground of the relay's coil? BTW, there's no picture in the archived thread.

I don't like to cut into wiring, so will be pulling the connectors from the factory plugs and making short pieces of wire and terminals where needed.

Yes, I am this ****.

 

looks good to me

 

Thank you.

 

Interesting. I did this on my own after I got sick of dead switches, never knew there was a guide for it.

Nice trick, brought up the brightness of my lights a bit too.