parking lights stay on
#1
Rotary Enthusiast
Thread Starter
Join Date: Oct 2002
Location: houston
Posts: 905
Likes: 0
Received 0 Likes
on
0 Posts
parking lights stay on
i re-soder my computer..i put the key in and all the check lights come on now along with the beep beep noise...so i guess that's fixed..however, my parking lights still remain on even after i turned the **** to shut the lights off located on the left of the steering wheel....my headlights work fine..but parking lights stay on continuous...some please help me...thanks
#2
FC Mobsta
The parking break will also come on if you have a leak/failure in your break system (i.e. master cylinder failure). Not sure if thats your problem..sounds electrical if you just re-sodered.
#3
Rotary Enthusiast
Thread Starter
Join Date: Oct 2002
Location: houston
Posts: 905
Likes: 0
Received 0 Likes
on
0 Posts
well...actually i do have a leaking clutch master cylinder...but before i re-sodered the computer..it was doing the same thing with the parking lights...coult it be the clutchmaster cylinder?
Trending Topics
#11
Rotary Enthusiast
Thread Starter
Join Date: Oct 2002
Location: houston
Posts: 905
Likes: 0
Received 0 Likes
on
0 Posts
my lights stay on when the key is turn into the on possition.....however i cant seem to turn off the lights...(headlights work just fine and blinkers work fine too) when the key is not in the ignition at all it wont cut the lights on..only the headlights turn on without the key being in the ignition....anyone have any ideas?
#12
Former Moderator. RIP Icemark.
sure it is not the turn signals that are on and not the parking lights???
Sounds more like you resoldered the CPU incorrectly and the turn signals are on.
Remember parking lights include the side marker lights, tail lights, L plate lights, dash lights.
If it is indeed the parking lights, then the switch is bad or you have an aftermarket alarm that has a stuck relay.
Sounds more like you resoldered the CPU incorrectly and the turn signals are on.
Remember parking lights include the side marker lights, tail lights, L plate lights, dash lights.
If it is indeed the parking lights, then the switch is bad or you have an aftermarket alarm that has a stuck relay.
#13
Rotary Enthusiast
Thread Starter
Join Date: Oct 2002
Location: houston
Posts: 905
Likes: 0
Received 0 Likes
on
0 Posts
hmm...ok..in that case it might be the switch..cause yeah..the side markers and all the other stuff stays on..there is no alarm....the lights were like this even before i resodered the cpu...so u think it might be the actual switch right?
#15
Former Moderator. RIP Icemark.
again if it is truly the parking lights, either the switch is bad or you have a aftermarket alarm that has a stuck relay.
Or someone hacked up all your wiring and joined together some wires that should have been somewhere.
But its pretty easy to check...
Do they stay on when you unplug the light switch????
if they do you have hacked up wiring or again an aftermarket alarm issue.
If they don't.....
YOU HAVE A BAD SWITCH
Or someone hacked up all your wiring and joined together some wires that should have been somewhere.
But its pretty easy to check...
Do they stay on when you unplug the light switch????
if they do you have hacked up wiring or again an aftermarket alarm issue.
If they don't.....
YOU HAVE A BAD SWITCH
Thread
Thread Starter
Forum
Replies
Last Post
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM
gabescanlon
3rd Generation Specific (1993-2002)
4
09-05-15 12:04 AM