Oil Seal Faliure
#26
ok I just got in and the damn thing still smokes. This is what I did I let it warm up for about 5 minutes. Then I slowly upped the rpms from ~2.5k to 3k to 4k then I would bounce it to 5-6k then I did like 4 or 5 redlines. Still smokes like a bitch on crack. I took out the plugs which look nasty comming from an N/a point of view. I will take some pics in a second and post them up.
#29
It wasn't for 5 minutes. The warming up part was 5 minutes. I sat there for 15 minutes reving it and some redlining too. I can't smell ****! :/
If you can see these well enough Rotor #1's plugs are noticably darker than Rotor #2's plugs. And both are really rich. :/
If you can see these well enough Rotor #1's plugs are noticably darker than Rotor #2's plugs. And both are really rich. :/
#30
Rotary Enthusiast
Join Date: Dec 2002
Location: Darwin, NT, Australia
Posts: 1,228
Likes: 0
Received 0 Likes
on
0 Posts
Hrmmmm
either it is injecting WAAAAY too much fuel into that motor or the oil control seals are actually gone.
Ooor...
where did you add the 2stroke into the engine?
isit possible there is still some left in the inlet?
either it is injecting WAAAAY too much fuel into that motor or the oil control seals are actually gone.
Ooor...
where did you add the 2stroke into the engine?
isit possible there is still some left in the inlet?
#31
OH and another thing happened right now. It won't idle anymore. I have to keep it at 1200 or above with the accelarator or it will slowly stumble and stall.
Two other things I noticed is when I would rev it high it would lessen the amount of smoke that would come out but as soon as it goes back down it will start to smoke again. And the one thing that freaked me out is that the dipstick was raised. I specifically remember putting it in and all the way down.
Two other things I noticed is when I would rev it high it would lessen the amount of smoke that would come out but as soon as it goes back down it will start to smoke again. And the one thing that freaked me out is that the dipstick was raised. I specifically remember putting it in and all the way down.
#33
Originally posted by White_FC
Hrmmmm
either it is injecting WAAAAY too much fuel into that motor or the oil control seals are actually gone.
Ooor...
where did you add the 2stroke into the engine?
isit possible there is still some left in the inlet?
Hrmmmm
either it is injecting WAAAAY too much fuel into that motor or the oil control seals are actually gone.
Ooor...
where did you add the 2stroke into the engine?
isit possible there is still some left in the inlet?
Thread
Thread Starter
Forum
Replies
Last Post