No Fuel??
#51
Moderator
iTrader: (1)
If you don't have this relay then you would need to check the location where the relay would be and you would find the plug for the sensor. You would then see if the Blue/Red wire supplying voltage to the relay is jumpered to the Blue/Green wires which power the fuel pump.
#52
Paper mache seals
iTrader: (1)
Join Date: Apr 2006
Location: Linthicum
Posts: 682
Likes: 0
Received 0 Likes
on
0 Posts
Id say without question I do NOT have that relay in place. I dont have the wiring to the location either, as it was on the body harness from the donor car, which I no longer have. Does the ecu need to see this 12v/2v signal to fire the injectors?
#56
Paper mache seals
iTrader: (1)
Join Date: Apr 2006
Location: Linthicum
Posts: 682
Likes: 0
Received 0 Likes
on
0 Posts
Ive tried testing the signal wires from the ecu using a voltmeter, to see if the 12v signal drops at all from the grounds hitting and it doesn't appear to be. Never thought of an LED, that's a good idea, I will give it a go. The grounds that are meant to go from the ecu to the engine all appear to be good. Both from visual, and the continuity from the wires at the ecu to the chassis itself. I checked continuity from the plugs on the ecu for the engine grounds to the passenger seat front bolts, and got clear continuity. I have not checked the timing no and I will do that as well. Do you think timing would be the issue if I'm seeing like, absolutely zero fuel on the plugs? not even a smell of it if I crank the the car with no plugs in.
#57
Moderator
iTrader: (1)
If you try the LED trickthen focus on the primary injectors since the secondaries don't work upon starting or idling the engine. One wire goes to the Light Green injector wire and the other LED wire goes to a pin which has voltage w/key to start (pin 1B B/W wire). If the ECU is correctly firing a primary injector the bulb should flash. 3W=front primary and 3Y=rear primary.
Last edited by satch; 12-25-13 at 11:05 AM.
#58
Paper mache seals
iTrader: (1)
Join Date: Apr 2006
Location: Linthicum
Posts: 682
Likes: 0
Received 0 Likes
on
0 Posts
So when tested at the ECU both injectors are firing which is... puzzling. Could it just be that the ground isnt strong enough or something? I was pretty confident that it wasnt going to set off the LED, but in a very metered manner, both of them seem to be firing. At least at the ecu.
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM