new rebuild having cooling problems
#1
new rebuild having cooling problems
i just dropped a rebuilt motor in and got it started and i can't seem to get the needle on my gauge to 1/4 it's a little below 1/2. The top hose going to the radiator isn't gettting pressurized like my previous rx7's were i don't know if this is what it's suppose to do.
also the engine doesn't like to idle at lower rpms do i have to put some miles on it for it to run better?
also the engine doesn't like to idle at lower rpms do i have to put some miles on it for it to run better?
Thread
Thread Starter
Forum
Replies
Last Post
ray green
1st Gen General Discussion
2
09-02-15 06:35 AM