need help with a couple problems
#1
Junior Member
Thread Starter
Join Date: Feb 2008
Location: Mooresville, NC
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
need help with a couple problems
i'm fairly new to rotarys so i dont know my way around these motors too good. when i bought my car and was on my way driving it home the heater hose gave out so i cut a lil bit off and put it back on and that got me home. got a new hose and put it on and noticed that my speedometer and oil pressure were not working so i just figured i unhooked something. i found 2 connectors that were unhooked but i couldnt find anything to hook them into. i just need help finding where they go and i have a pic to help out. thanks in advance for the help
#2
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
the oil pressure Sender is under the oil filter,so that Single wire needs to be hooked up.(uh..I can't see because the pics are Dark,so I am assuming that the wire is OFF there!)..it is Spade like I believe..the Speedometer is Gear driven From the Transmission,.First see if the cable is OK..you wil need to make usre that the END that goes into the Trans is OK,and the Pin(from the cable) is sitting in the Gear on the "inside" of the trans..Then make sure the Cab;e is Secured to the transmission..another spot would be AT the Speedometer itself.that would Involve taking the Gauge Cluster out and Inspecting it there.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
The1Sun
1st Generation Specific (1979-1985)
0
09-07-15 10:21 PM