Need build help!!!
#26
SLOHAWK
Thread Starter
Join Date: Oct 2007
Location: 48430
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
every rx7 has 3 harnesses. the alternator harness plugs into the main harness. but it is its own harness. Even rotaryressurction says to do the turbo swap you use the N/A Main and Alternator harnesses and the Engine Harness from a Turbo. Did you do a swap yourself?
#29
My car hates me
iTrader: (1)
Join Date: Nov 2005
Location: SE Wisconsin
Posts: 380
Likes: 0
Received 0 Likes
on
0 Posts
Even though this thread shifted topics...
The seized engine could be caused by one of the apex seals not being seated right. I had this happen during my rebuild. I had to take the whole thing apart and find the apex corner that caused it. After fixing that and putting the engine back together it turned over no problem.
The seized engine could be caused by one of the apex seals not being seated right. I had this happen during my rebuild. I had to take the whole thing apart and find the apex corner that caused it. After fixing that and putting the engine back together it turned over no problem.
#30
SLOHAWK
Thread Starter
Join Date: Oct 2007
Location: 48430
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
I was going to start a new thread but, its still me trying to get my car to run.
I rebuilt my engine and it turns fine now. But i think i put the end float together wrong. like too many bearings or something
I rebuilt my engine and it turns fine now. But i think i put the end float together wrong. like too many bearings or something
Thread
Thread Starter
Forum
Replies
Last Post