Razmus

iTrader: (2)

i posted this in the rotary tech, but it seems everyone reads in here so.........

ok, so i changed all my belts today. and when i was taking the air pump belt off i loosened the bottom bolt and that didnt seem to loosen the belt at all. i tried putting the bolt back to its original position but im not sure if it went on there right.

when i finished putting everything back, i started the motor up and everything was fine. i put my head in the engine bay to make sure all the belts were going straight and everything was running smooth and i started smelling like something burning. i reved it up and noticed smoke coming out of the sir pump area...did i do something wrong? i dunno whats up.

i cut the car off and tried again about 30 minutes later and again it did the same thing.

Fc3s88rx7

Lol trace your steps and see if you put everything back in the same pleace
use an instruction manual

Razmus

iTrader: (2)

thanks dood. i tried putting the bolt back how it was and i though i put it back in the same place because i tried aligning the outline of where bolt was.