low vac at idle but high compression
#26
Lives on the Forum
Originally Posted by mort2002
what about the bigger nipple on the LIM facing the fire wall. iver never seen anything about it, in any drawing..
That 6mm fitting is for the oil injector vacuum splitter.
as for the pcv; i just have the crank nipple and the filler neck nipple going to a tee with a filter on it?? does that sound good?
Just as long as it isn't plugged / capped.
any thiughts on eliminating the 2nd dait air bleeds and the big nipple on the back?
There's a lot of extra fittings that run before the TB, so it's just a nice way of using those extra fittings and not worrying about capping them.
BTW i thought the oil metering lines went to the middle vac nipple on the back no the bottom one?? wich one is right?
-Ted
#27
Rotary Enthusiast
Thread Starter
iTrader: (1)
Join Date: Jul 2003
Location: Prosser Washington
Posts: 1,248
Likes: 0
Received 0 Likes
on
0 Posts
well my problem is i only have 3 vac nipples on the back of my TB. is that cause i have a JDM motor?? so is there a different vac diagram to use?? i hae a small nipple a med nipple and than a small nipple again. thanks a bunch.
#28
Lives on the Forum
Originally Posted by mort2002
well my problem is i only have 3 vac nipples on the back of my TB. is that cause i have a JDM motor?? so is there a different vac diagram to use?? i hae a small nipple a med nipple and than a small nipple again. thanks a bunch.
-Ted
#30
Lives on the Forum
I can't confirm that.
The only JDM set-up I've seen was 2 on top and med on bottom.
I know that set-up.
I've never seen a small-med-small set-up like you described.
At the very least, it's not US-spec.
-Ted
The only JDM set-up I've seen was 2 on top and med on bottom.
I know that set-up.
I've never seen a small-med-small set-up like you described.
At the very least, it's not US-spec.
-Ted
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
ncds_fc
New Member RX-7 Technical
1
08-15-15 10:06 AM