Little Tube On Intr. Housing By Oil Filler?
07-31-03, 02:52 PM
#1
RIP Icemark
Thread Starter
iTrader: (4)
Join Date: Oct 2002
Location: Aloha OR
Posts: 1,481
Likes: 0
Received 0 Likes
on
0 Posts
Little Tube On Intr. Housing By Oil Filler?
Well guys I am going to be installing the motor in a hour or so, and I am making sure that I have everything hooked up properly. When I did this I noticed that the little nipple/tube on teh intermediate housing has nothing going to it. So where does this go?
Thanks
-Justin
Thanks
-Justin
07-31-03, 03:58 PM
#2
White Comet
Join Date: Jan 2002
Location: Orange County
Posts: 2,145
Likes: 0
Received 0 Likes
on
0 Posts
Is it on the drivers side next to the knock sensor? If so, its part of the positive crankcase ventilitation system (PCV) and needs to be properly routed to a non pressurized source.
07-31-03, 04:09 PM
#3
RIP Icemark
Thread Starter
iTrader: (4)
Join Date: Oct 2002
Location: Aloha OR
Posts: 1,481
Likes: 0
Received 0 Likes
on
0 Posts
So basically just put a tube on it and route it to atmosphere?
And just to make sure its right next to the tube on the oil filler neck that goes to the vacum harness.
And just to make sure its right next to the tube on the oil filler neck that goes to the vacum harness.
Trending Topics
08-02-03, 01:52 AM
#9
I'm a boost creep...
Join Date: Jan 2002
Location: Auckland, New Zealand
Posts: 15,608
Likes: 0
Received 8 Likes
on
8 Posts
Just stick a hose on the nipple, run it down under the car somewhere and cable tie it to something. All you're doing is venting the sump outside engine bay instead of in it.
Thread
Thread Starter
Forum
Replies
Last Post
KAL797
Test Area 51
0
08-11-15 03:47 PM